Knowledgebase
Hitron Cable Gateway CGN3 Bridge Mode:
Posted by George Chu on 25 May 2018 09:02 PM

Hitron Cable Gateway CGN3 Bridge Mode:

 

DISABLING GATEWAY MODE AND ALLOW CUSTOMERS OWN ROUTER (BRIDGE MODE)

 

  1. Type 192.168.0.1 in address bar.
  2. Login with the defaults:  User name: cusadmin  Password: password
  3. Clicking \"Basic\" and then \"Gateway Function\"
  4. Switch the Residential Gateway Function setting from Enabled to Disabled and click on \"Save Changes\" (You’ll be advised that all of your device’s router features are about to be switched off)
  5. Click OK to continue, and the device will reboot into Bridge Mode. Once the modem is online, plug a router into port one – top port to test their connectivity.  While in bridged mode, only port one will be active on the gateway. Configure your own router with a DHCP server. 
  6. If you want to put the modem back into gateway mode, factory reset the modem by pressing the reset button on the back for more than 10 seconds.

 

(3 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk Software by Kayako Resolve